F122
Input #12 Terminal Assignment
Program
Terminal Selection Parameters
⇒
Assignment
⇒
S12
This parameter selects the functionality of the #12 input terminal.
Note: The S12 input terminal may be used without the ASD-Multicom option
board.
Without the ASD-Multicom option board the S12 terminal assignment
information will be stored in volatile memory. The terminal assignment
information will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable terminal #12 to 1 of the 68 possible
functions that are listed in
Table 6 on pg.
Input #13 Terminal Assignment
Program
⇒
Terminal Selection Parameters
Assignment
⇒
S13
This parameter selects the functionality of the #13 input terminal.
Note: The S13 input terminal may be used without the ASD-Multicom option
board.
Without the ASD-Multicom option board the S13 terminal assignment
information will be stored in volatile memory. The terminal assignment
information will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable terminal #13 to 1 of the 68 possible
functions that are listed in
Table 6 on pg.
Input #14 Terminal Assignment
Program
Terminal Selection Parameters
⇒
Assignment
S14
⇒
This parameter selects the functionality of the #14 input terminal.
Note: The S14 input terminal may be used without the ASD-Multicom option
board.
Without the ASD-Multicom option board the S14 terminal assignment
information will be stored in volatile memory. The terminal assignment
information will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable terminal #14 to 1 of the 68 possible
functions that are listed in
Table 6 on pg.
H7 ASD Operation Manual
Input Terminal
⇒
67.
⇒
Input Terminal
67.
Input Terminal
⇒
67.
Direct Access Number — F122
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F123
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F124
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F124
65