Table of Contents
Advertisement
F018
Preset Speed #1
Program
Pattern Run Control
⇒
Up to 15 output frequency values that fall within the Lower Limit and the
Upper Limit range may be programmed into the drive and output as a Preset
Speed. This parameter assigns an output frequency to binary number 0001 and
is identified as Preset Speed #1. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed.
Perform the following setup to allow the system to receive Preset Speed
control input at the S1 – S4 terminals:
1.
Program
⇒
Fundamental Parameters
Control Terminal Strip.
⇒
2.
Program
Terminal Selection Parameters
Preset Speed Command 1). Repeat for S2 – S4 as Preset Speed
Command 2 – 4, respectively (all Normally Open).
Note: The default setting of S4 is EOff, but this terminal may be re-assigned as
the MSB.
3.
Program
⇒
Frequency Setting Parameters
Enter twice and set an output frequency as Preset Speed #1; repeat for
Preset Speeds 2 – 15 as required).
4.
Program
⇒
Frequency Setting Parameters
Speed Modes (Enable/Disable).
When Enabled, the direction, accel/decel, and torque settings of the Preset
Speed being run are used.
When Disabled, only the speed setting of the Preset Speed being run is
used.
5.
Place the system in the Remote mode (Local|Remote LED Off).
6.
Provide a Run command (connect F and/or R to CC).
Connect S1 to CC to run Preset Speed #1 (S1 to CC = 0001 binary).
With S1 – S4 configured to output Preset Speeds
may be applied to S1 – S4 of the Control Terminal Strip to run the associated
Preset Speed. If bidirectional operation is required, F and R must be connected
to CC and Use Preset Speeds must be enabled at F380.
With S1 being the least significant bit of a binary count, the S1 – S4 settings
will produce the programmed speed settings as indicated below.
Preset Speeds are also used in the Pattern Run mode.
Preset Speed
S4
Number
(MSB)
1
0
2
0
3
0
4
0
5
0
6
0
7
0
Note:1 = Terminal connected to CC. Presets 1 – 7 are shown, but
may continue to Preset Speed #15.
H7 ASD Operation Manual
Preset Speeds
1
⇒
⇒
⇒
Standard Mode Selection
⇒
Input Terminals
⇒
Preset Speeds
⇒
Preset Speed Mode
(F115
– F118), 0001 – 1111
S1
S3
S2
(LSB)
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
Direct Access Number — F018
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
⇒
Use
⇒
S1 (set to
⇒
1 (press
⇒
Use
Output
F018
setting
F019
setting
F020
setting
F021
setting
F022
setting
F023
setting
F024
setting
F018
55
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
