Table of Contents
Advertisement
F703
Frequency Display Resolution
Program
Utility Parameters
⇒
The parameter sets the number of decimal places to be displayed during non-
Accel/Decel functions.
Accel/Decel Special Display Resolution
Program
⇒
Special Control Parameters
This parameter sets the number of decimal places to be displayed for Accel/
Decel functions.
Prohibit Initializing User Parameters During Typeform
Initialization
Program
⇒
Special Control Parameters
Prohibit Initializing User Parameters During Typeform Initialization
This parameter Enables/Disables the ability to initialize user parameters during
a Type Form initialization.
Settings:
Allowed
Prohibited
V/f Group
No path available (Direct Access Only)
While operating using the LED Keypad Option 1 of 4 V/f groups may be
selected and run. Each V/f group is comprised of 4 user-defined variables: Base
Frequency, Base Frequency Voltage, Manual Torque Boost, and Electronic
Thermal Protection. Expanded descriptions of these parameters may be found
in this section
(Direct Access Parameter
Note: If using the LCD EOI, press ESC from the Frequency Command screen
to access this parameter.
166
Display Units
⇒
⇒
Accel/Decel Special
⇒
Special Parameters
Information).
Direct Access Number — F703
Parameter Type — Numerical
Factory Default — 0.1
Changeable During Run — Yes
Minimum — 1
Maximum — 0.01
Direct Access Number — F704
Parameter Type — Numerical
Factory Default — 0.1
Changeable During Run — Yes
Minimum — 1
Maximum — 0.01
Direct Access Number — F709
Parameter Type — Selection List
⇒
Factory Default — Allowed
Changeable During Run — Yes
Direct Access Number — F720
Parameter Type — Selection List
Factory Default — 1
Changeable During Run — Yes
H7 ASD Operation Manual
F720
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
