Sony DVS-9000 User Manual page 80

Switcher system
Hide thumbs Also See for DVS-9000:
Table of Contents

Advertisement

2
3
4
5
Saving user-defined settings
To save the Setup settings
Use the following procedure.
1
2
To save the Initial Status settings
Use the following procedure.
80
Setup for the Whole System
In the <Start Up Mode> group, select one of the following modes.
Resume: When this is on, Resume mode is enabled.
Custom: When this is on, Custom mode is enabled.
For information about Resume mode and Custom mode, see "System
Setup" in Chapter 1 (Volume 1).
Note
The Resume mode is only valid when a switcher or control panel is
selected for the setting.
When Custom mode is selected, in each of the <Setup> group and <Initial
Status> group, select one of the following.
User: When this is on, user-defined settings are used for the Setup or
Initial Status settings. For the method of saving the user-defined
settings, see the next item.
Factory: When this is on, factory default settings are used for the Setup or
Initial Status settings.
To confirm the settings, press [Execute]. If you want to cancel the setting
changes without saving them, press [Clear].
When [Execute] is pressed, a confirmation message appears.
Select [Yes].
The start-up state settings are saved.
After selecting the devices the settings apply to, in the System>Start Up
menu, press [Setup Define].
A confirmation message appears.
Press [Yes].
This saves the setup settings for the selected devices in non-volatile
memory within the respective devices.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvs-9000sf

Table of Contents