Setting The Signal Format And Screen Aspect Ratio (Format Menu); Setting The Signal Format And Screen Aspect Ratio; (Format Menu) - Sony DVS-9000 User Manual
Switcher system
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
In the <Setup Target> group, set the [System 1] or [System 2] button to ON,
then carry out the setup. You can also set both to ON, and make the settings
simultaneously on the two systems.
Setting the Signal Format and Screen Aspect Ratio
(Format Menu)
To set the format, that is, the frame frequency and number of scan lines handled
by each device, and the screen aspect ratio, use the System>Format menu.
To display the Format menu
In the Engineering Setup menu, select VF1 'System' and HF3 'Format.'
Note
After changing any of the following settings, be sure to press [Execute] to save
the new values. If you want to cancel the setting changes without saving them,
press [Clear].
Note that since the [Execute] button is in the System>Format menu, when you
make settings in a submenu, it is essential to remember to return to the
System>Format menu and press the [Execute] button to save.
Setting the signal format
Use the following procedure.
1
2
3
Setting the screen aspect ratio
Use the following procedure.
78
Setup for the Whole System
In the <Frame/Field Rate> group of the System>Format menu, select the
system operating frequency.
For more details, see "System Setup" in Chapter 1 (Volume 1).
Press the [Active Line/Aspect].
The Active Line/Aspect menu appears.
The status area shows the number of active scan lines and screen aspect
ratio for the switcher and connected DME.
In the <Active Line> group, select the number of active scan lines.
Advertisement
Table of Contents
