Setup Relating To Switcher Processor; Settings For Switcher Configuration (Config Menu); Setting The Operating Mode - Sony DVS-9000 User Manual
Switcher system
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
Setup Relating to Switcher Processor
Settings for Switcher Configuration (Config Menu)
To make settings for the switcher processor, use the Switcher>Config menu.
To display the Config menu
In the Engineering Setup menu, select VF3 'Switcher' and HF1 'Config.'
The status area shows the output signal assignment for each operating bank.
Adjusting the reference phase
To adjust the switcher internal reference phase, adjust the following parameter
in the Switcher>Config menu.
Knob
3
Specifying the video switching timing
In the <Switch Timing> group of the Switcher>Config menu, select one of the
following.
Any: Not specified
Field 1: Field 1 (odd fields)
Field 2: Field 2 (even fields)
Setting the operating mode
In the <M/E Config> group of the Switcher>Config menu, select the operating
mode for the M/E or P/P bank from the following.
• Standard mode
• Multi Program mode
• DSK mode (P/P only)
For details of the modes, see "Switcher Setup" in Chapter 1 (Volume 1).
Note
When Multi Program mode is selected, two or more transition type indication
may light. It is also possible that more than one "Transition Type" has been
selected in the Misc>Transition menu for the M/E.
Parameter
Adjustment
Phase
Switcher internal reference phase
Setting values
−32.00 to +96.00
Setup Relating to Switcher Processor
103
Advertisement
Table of Contents
