Table of Contents
Advertisement
procedure
For models:
E30GC74GPS
E36GC75DSS
E36GC75ESS
E36GC75GSS
E36GC76EPS
E36GC76GPS
Tools & Materials:
Phillips-Head
Screwdriver
Hammer
Awl or Punch
Drill with 3/4" drill bit
2 - Plastic Inserts
(73209-2470)
Silicone Caulk
Aluminum Tape
162
project planning
30" & 36" Gas Slide-In Cooktop Power Cord Relocation Instructions
To install an Electrolux ICON
Downdraft Vent, cooktop power cord MUST be relocated to underside of unit.
Please have qualified electrician perform following rewiring procedure in accordance with
local and national electric codes.
1
4
7
10
1.
Remove electrical access panel from rear
of cooktop.
2.
Disconnect power cord and ground wires,
then remove from cooktop.
3.
Locate area for new hole to be drilled, 1/2" in
from back edge on underside of cooktop, then
mark hole location using an awl or punch.
4.
Use 3/4" drill bit to drill new hole completely
through.
5.
Route power cord wires through hole.
®
Gas Slide-In Cooktop in combination with an Electrolux ICON
2
5
8
11
6.
7.
8.
9.
10.
11.
3
6
9
Place plastic inserts in upper and lower
drilled holes to protect cord.
Knot power cord to secure into place.
Reconnect power cord and ground wires.
Fill remaining hole surrounding power
cord with silicone caulk.
Cover both sides of original hole with two
layers of aluminum tape.
Screw electrical access panel back
in place.
®
Hide quick links:
Advertisement
Table of Contents
