Table of Contents
Advertisement
42" Built-In Refrigerators
Installation Specifications
•
Product Weight – 610 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 or 20 Amps
•
Connected Load (kW Rating) @ 120 Volts = 0.65 kW
(For use on adequately wired 120V, dedicated circuit
having 2-wire service with a separate ground wire.
Appliance must be grounded for safe operation.)
•
Amps @ 120 Volts = 5.4 Amps
•
Always consult local and national electric & plumbing
codes.
•
Cutout must be prepared with electrical and water supply
located as shown. When possible, recess copper water
line and electrical outlet.
•
Water line can enter opening through floor or rear wall.
Copper tubing recommended between cold water line and
water connection location. Water line tubing recommended
is 48" minimum length by 1/4" diameter. Installation of
easily accessible shutoff valve in water line required.
•
Optimum door swing factory set for 130°. When installing
next to wall where handle may make contact, allow 4"
minimum clearance for 90° door swing. At 90° door stop
position, drawer access will be maintained but removal
will be restricted.
•
Refrigerator must be placed on level surface of hard
material, same height as flooring. Surface must support
approximately 1500 Lbs. when fully loaded. Unit
equipped with 4-point leveling.
e l e c t ro l u x i c o n . c o m
planning
information
For model:
E42BS75EPS
Note:
For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
®
PureAdvantage
Water Filter Replacement
Cartridge
PN # EWF2CBPA
107
Hide quick links:
Advertisement
Table of Contents
