Rack Mounting - Sony Betacam SX DNW-A100 Maintenance Manual
Digital video hybrid recorder
Hide thumbs
Also See for Betacam SX DNW-A100:
- Maintenance manual (506 pages) ,
- Operation manual (134 pages) ,
- Brochure & specs (14 pages)
Table of Contents
Advertisement
1-6. Rack Mounting
1-6. Rack Mounting
Explains how to mount this unit into a 19-inch standard
rack.
Be sure to mount this unit into a rack accurately as follow-
ing the procedure with the specified rack mount rail.
c
. Use the specified rack mount rail.
If not, injury could occur by drop of the unit because
strength of rail is not enough.
. To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
m
. When other equipment with built-in hard disk drive are
already mounted in the same rack for mounting this unit,
turn off the power of the equipment which is already
mounted before mounting this unit in the rack.
. Never remove the upper lid, bottom plate, and so on
during rack mounting.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
. To reduce an increase in the internal temperature of this
unit, leave each space on the top and bottom of this unit
by 1U.
. Adjust the temperature inside the rack within the range
of the unit's operating temperature.
Specified Rack Mount Kit
RMM-111 (Option) or
RMM-110 (Option)
The color of rack angle of RMM-111 fits to the unit.
RMM-110 is the same consistance, strength and dimension
as RMM-111, but the color of rack angle is different.
n
It is recommended to use the BKFC-53/2 when this unit is
mounted in the FLEXICART.
Parts Packed in RMM-110/111
. Slide rails ......................................... 2
. Rack angles (handle) ....................... 2
. Rail brackets .................................... 4
. Plate nuts (large) ............................. 4
. Plate nuts (small) ............................. 4
. Screws (PSW4 x 16) ...................... 4
. Screws (B4 x 8) .............................. 8
1-4
. Hexagon socket head cap screws .... 8
. Flat washers ..................................... 8
. Screws (RK5 x 14) ......................... 2
. Ornamental washers ........................ 2
. L-shaped hexagon wrench............... 1
Rack Mounting Procedure
. Remove of feet
c
Move the unit as gently as possible to avoid shock to the
hard disk drive. Pay particular attention to move of this
unit without feet.
1. Set the unit with its right side panel down.
n
Lend your hand so that the lower handle does not hang
down.
2. Unscrew the four screws and remove the feet from the
bottom plate of the unit.
3. Replace the unit to the horizontal position.
Foot
PS4 x 14
Foot
c
Keep these screws and the feet that are removed in this
procedure carefully.
Be sure to attach the feet if the unit is used after removing
from the rack. If not, the hard disk drive may break down
by mechanical vibration, shock, etc.
Tightening torque: 98 x 10
_2
PS4 x 14
N . m {10 kgf . cm}
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Advertisement
Table of Contents
