Table of Contents
Advertisement
56/128 Transport and storage
Transport after
previous operation
Bosch Rexroth AG, CytroBox, RE 51057-B/11.19
6.1.1 Preparing for transport
Prior to transport, make the following preparations:
▶
Check the space required for installation of the hydraulic power unit at the
place of use.
▶
Check the transport route.
▶
Depending on the type of transport, ensure additional space besides and above
the hydraulic power unit.
▶
For transportation after operation, drain the hydraulic fluid from the oil tank.
6.1.2 Transport using forklifts and similar floor conveyors
To transport the hydraulic power unit using a forklift, proceed as follows:
1.
Move the fork of the forklift into the recesses provided for this purpose under
the packaging of the hydraulic power unit or under the hydraulic power unit
secured for transport.
2.
Carefully lift the load to check the center of gravity position. Ensure a stable
center of gravity position.
3.
Make sure that the hydraulic power unit cannot move out of the intended
position.
4.
Secure the hydraulic power unit against the occurring acceleration forces and
the related undesired motion of the hydraulic power unit.
5.
During transport, only lift the hydraulic power unit as far off the floor as
necessary for transport.
S
Fig. 11: Transport using a forklift
6.1.3 Transport using lifting gear
For transport, the hydraulic power unit can be connected to lifting gear.
Use the eyebolts only for short-term transport of the hydraulic power unit,
e.g. to lift it into a drip pan.
Avoid jerky acceleration and deceleration forces.
The total weight of the hydraulic power unit varies depending on the version and
customer-specific extension. Lifting using eyebolts is admissible up to a maximum
total weight of 800 kg.
S
Advertisement
Table of Contents
