Table of Contents
Advertisement
24/128 Product information
Operating unit of
the drive controller
Bosch Rexroth AG, CytroBox, RE 51057-B/11.19
5.3 Functional description
5.3.1 Drive controller
The drive controller represents the central control unit. It controls, regulates and
monitors the operation of the drive unit. When faulty states are detected, they are
reported and reacted to as defined. This may result in the shutdown of the CytroBox.
Access to the parameters is possible by the PC-based project planning tool
IndraWorks DS. Depending on the type of control communication used, IndraWorks
is connected either via the service interface of the control system or directly with the
drive controller.
You will find further information on this later in this chapter and in chapter 8.1.8
"Commissioning of the "electronics"".
The control section of the drive controller, see Fig. 7, pos. 14 on page 50 is
equipped with an operating unit. On its 8-digit display, operating states, activated
commands and error diagnoses and any active warnings and error messages are
shown. Using the keys, settings can be adjusted, information can be viewed, and
some commands can be executed.
Fig. 1: Operating unit with 8-digit display (standard display)
A detailed functional description of the operating unit is provided in the
application description "IndraDrive, MPx-20, functions", see chapter 1.2
"Required and amending documentation".
Advertisement
Table of Contents
