Toshiba GR-200 Series Instruction Manual page 792

Multi functional protection ied

Hide thumbs Also See for GR-200 Series:

Edit GOOSE subscribe

GOOSE subscribe function is configured to receive GOOSE messages published

by other IEDs. Figure 11.3-21 exemplifies the GOOSE Subscribe screen; the user

can select the necessary signals to be added. For example, "Bay1 GRE200-1" is

the current IED; "Bay2 GRE200-2" is the other IED. "List 1" is GOOSE publisher

of GRE200-1; "List 2" is GOOSE subscriber for GRE200-2. The user can select the

GOOSE publisher from GRE200-1 and add to the GOOSE subscriber of GRE200-

In the example shown below, select the required variable and click Add. Similarly,

the user can delete the variables.

When the user adds a signal to the GOOSE subscribe list from the other IED,

then the same signal is automatically added in the Signal List of the current IED.

Figure 11.3-21 GOOSE Subscribe

Note: The user can monitor about the GOOSE message on the LCD screen. See Chap.

Edit Control function

The Data IDs (i.e., Signal Number) starting with "5" is used for control function

when the IED has the control function by default. The user should check whether

the required signals are mapped in the default configuration. The user can edit

and add the control signals to the LN as described in Chapter 11.3.3(iv).

In an IED, usually an output Data ID of a protection function is assigned to LN

variable. However, for the control application, the IED is capable of receiving

command from the SAS server. To control a device (such as a circuit breaker), the

input point* (Data ID) in the control application should be configured to receive

commands from the SAS sever (that is, selecting, operating or cancel command).

6F2T0200 (0.15)

GRE200 (1,2)

Chapters

Gre200-1 Gre200-2