Siemens SINUMERIK 840D Diagnostics Manual page 685
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
03.04
Error code
Error text
Extension 1
Extension 2
Explanation
Remedy
Error code
Error text
Extension 1
Extension 2
Explanation
Remedy
Error code
Error text
Extension 1
Extension 2
Explanation
Remedy
Error code
Error text
Extension 1
Extension 2
Explanation
Remedy
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
0026H
Servo declared FSD as MSD.
-
NC drive number
The NC is attempting to register an FDD module as an MSD. Possible communication
failures on the drive bus or control module defective.
Replace the control module. Check cable connections, perform remedial measures
(check shielding or ground connection).
0027H
Servo declared FSD as MSD.
-
NC drive number
The NC is attempting to register an MSD module as an FDD. Possible communication
failures on the drive bus or control module defective.
Replace the control module. Check cable connections, perform remedial measures
(check shielding or ground connection).
0028H
Incorrect IPU_submodule plugged into direct measurement system.
Read K1C register of the relevant PCU ASIC.
NC drive number
Only certain submodules are permitted for the direct measurement system. An illegal sub-
module has been detected.
Replace the control module. Check cable connections, perform remedial measures
(check shielding or ground connection).
0030H
Errors in interpreter that can no longer be handled through the STF protocol.
0x01 ;Unsupported ROSCTR
0x02 ;Illegal ROSCTR
0x03 ;Job management "defective"
0x04 ;Incorrect PDUREF on acknowledgement
0x05 ;Acknowledgement not permitted at this time
0x06 ;Acknowledgement is not supported
0x07 ;Illegal PROTID
0x08 ;Illegal PARLG (uneven)
0x09 ;Buffer management "defective"
0x0A ;Illegal PI identifier (internal)
0x0B ;Illegal internal state of PI restart
0x0C ;Sequential circuit in WRITEDATA "defective"
0x0D ;Illegal parameter on REFRESH_PIZUST
NC drive number
Either unrecoverable errors have been detected when communicating on the drive bus, or
the drive software is no longer consistent.
The cause is either a faulty drive bus interface or a hardware error on the control module.
Check the drive bus cable and cable connections, perform remedial measures (check
shielding or ground connection). Replace the control module.
1 Alarms
1-685
Hide quick links:
Advertisement
Table of Contents
