Siemens SINUMERIK 840D Diagnostics Manual page 215
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
10.04
Reactions:
Remedy:
Program Continuation:
14549
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14550
Parameters:
Definitions:
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Check tool definition. Change edge radius.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 contour tool: impermissible programming. Code no. %3
%1 = Channel number
%2 = Block number, label
%3 = Error code
Impermissible programming has been found for contour tools on active tool radius com-
pensation. The error cause is explained in detail by the error code.
1: In G code group 17, KONT is active during activation
2: In G code group 17, KONT is active during deactivation
9: In G code group 40, CUTCONOF is not active
10: Reprogramming of G41 / G42 in already active tool radius compensation not permis-
sible
20: Circle with more than one rotation not permissible
21: Ellipse (circle not in compensation level)
23: Involute not permissible
24: Several polynomials not permitted in one block only. These blocks could be created
by e.g. COMPCAD or G643.
30: Preprocessing stop not permitted
41: Starting point of first compensation block cannot be reached by anyone of the defined
cutting edges
42: End point of last compensation block cannot be reached by anyone of the defined
cutting edges
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Change NC program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 contour tool: impermissible tool contour change. Code no.
%3
%1 = Channel number
%2 = Block number, label
%3 = Error code
A new tool with deviating tool contour was activated for contour tools on active tool radius
compensation
The error cause is explained further by an error code.
If the error code is an integer, the lower-value three decimal places specify the number of
the edge, in which the error was detected, while the thousandth digit explains the reason
in more detail.
-1: The tool was deleted.
-2: The number of contour elements (edges) explaining the tool, has changed.
1 Alarms
1-215
Hide quick links:
Advertisement
Table of Contents
