Siemens SINUMERIK 840D Diagnostics Manual page 244
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
15450
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15460
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15500
Parameters:
Definitions:
1-244
The alarm is output in the following situation:
The interpreter has detected an illegal instruction (e.g. a motion command) while process-
ing an INI file or a definition file (macro or GUD).
In a GUD file, the access security for a machine data is to be changed with REDEF,
although
an ACCESS file (_N_SACCESS_DEF, _N_MACCESS_DEF, _N_UACCESS_DEF) is
available.
Access rights for machine data can only be changed then via one of the ACCESS files
with REDEF.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Correct the INI, GUD or macro file.
• Correct part program.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 compiled program cannot be stored
%1 = Channel number
%2 = Block number, label
In the compile mode, a compiled program could not be stored. One of the following rea-
sons applies:
• Not enough memory
• Intermediate code line (compilate) too large
- Alarm display.
Create space in work memory or modify part program (make it less complex).
Clear alarm with the Delete key or NC START.
Channel %1 block %2 syntax error with modal function
%1 = Channel number
%2 = Block number, label
The addresses programmed in the block are not compatible with the modal syntax-deter-
mining G function.
Example:
N100 G01 ... I .. J.. K.. LF
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct the displayed block and ensure that the G functions and addresses in the block
are in agreement.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal angle of shear
%1 = Channel number
%2 = Block number, label
The function CSHEAR has been called with an illegal (impossible) angle of shear, e.g.
when the sum of angles between the axis vectors is greater than 360 degrees.
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
