HP ProCurve 5300xl Series Management Manual page 61

Advanced traffic

Hide thumbs Also See for ProCurve 5300xl Series:

Table of Contents

Show VLAN lists this

data when GVRP is

enabled and at least

one port on the switch

has dynamically

joined the designated

Figure 2-20. Example of "Show VLAN" for a Specific Dynamic VLAN

Changing the Number of VLANs Allowed on the Switch. In the default

VLAN configuration, the switch allows a maximum of 8 VLANs. You can

specify any value from 1 to 256.

For example, to reconfigure the switch to allow 10 VLANs:

Note that you can

execute these

three steps at

another time.

Figure 2-21. Example of Command Sequence for Changing the Number of VLANs

Changing the Primary VLAN. In the default VLAN configuration, the port-

based default VLAN (

reassign the Primary VLAN to any port-based, static VLAN on the switch. (For

Syntax: max-vlans < 1-256 >

Specifies the maximum number of VLANs to allow. (If GVRP

is enabled, this setting includes any dynamic VLANs on the

switch.) As part of implementing a new setting, you must

execute a write memory command (to save the new value to the

startup-config file) and then reboot the switch.

Note: If multiple VLANs exist on the switch, you cannot reset

the maximum number of VLANs to a value smaller than the

current number of VLANs.

DEFAULT_VLAN

Static Virtual LANs (VLANs)

) is the Primary VLAN. However, you can

Configuring VLANs

Show Quick Links

Table of Contents

Troubleshooting