Acceptance Test Wizard Of Sinumerik Operate; Introduction - Siemens SINUMERIK 828D Function Manual
Sinumerik operate acceptance test
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Acceptance test wizard of SINUMERIK Operate
3.1
Introduction
This chapter describes the acceptance test wizard of SINUMERIK Operate. A distinction is
made here between the drive-based Safety for the SINUMERIK 828D and SINUMERIK 840D
and the system-integrated Safety for the SINUMERIK 840D sl.
The following table gives you an overview of the available test types, depending on the
respective SINUMERIK controllers.
Overview of the SINUMERIK systems and Safety Functions
Option package/Functions
Basic Functions
Safe Torque Off (STO)
Testing of the Safe Torque Off (STO) verifies the following points for an
axis/drive:
● The hardware is functioning properly
● Correct wiring of the switch-off signal paths
● Correct assignment of the terminals for STO on the Control Unit
● Correct STO grouping (if available)
● Correct parameterization of the STO function
And in addition, the following points wherever Safe Brake Control (SBC)
is configured for the axis/drive:
● The brake is connected properly
● The hardware is functioning properly
● The SBC is parameterized correctly
● Forced checking procedure for the brake control
SINUMERIK Operate acceptance test
Function Manual, 08/2018, A5E39460574B AC
SINUMERIK 840D sl
Safety Integrated plus
x
3
SINUMERIK 828D
Safety Integrated
x
19
Advertisement
Table of Contents
