Siemens SINUMERIK 840DE sl Commissioning Manual page 67
For cnc shopmill
Hide thumbs
Also See for SINUMERIK 840DE sl:
- Commissioning manual (1734 pages) ,
- Function manual (356 pages) ,
- Manual (92 pages)
Table of Contents
Advertisement
11/2006
9855
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: WORD
Significance:
9999
MD number
Default setting: 0
Change becomes effective after: POWER ON
Data type: WORD
Significance:
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
$MM_ST_CYCLE_T AP_SETTINGS
Thread tapping setting with and without compensation chuck
Min. input limit: –
Protection level: 3/4
For thread tapping without compensation chuck
Units digit: Exact response
0: Exact stop response active as before cycle call
1: Exact stop G601
2: Exact stop G602
3: Exact stop G603
Tens digit: Feed–forward control
0: With/without feed–forward control active as before cycle call
1: With feed–forward control FFWON
2: Without feed–forward control FFWOF
Hundreds digit: Acceleration
0: SOFT/BRISK/DRIVE active as before cycle call
1: With jerk limiting SOFT
2: Without jerk limiting BRISK
3: Reduced acceleration DRIVE
Thousands digit: MCALL
0: For MCALL Reactivate spindle operation
1: Remain in position control for MCALL
For thread tapping with compensation chuck (see chapter 11.4 Analog spindles)
Units digit: Exact response
0: Exact response as before cycle call
1: Exact response G601
2: Exact stop G602
3: Exact stop G603
Tens digit. Feed–forward control
0: With/without feed–forward control active as before cycle call
1: With feed–forward control FFWON
2: Without feed–forward control FFWO
Hundreds digit: Brake application point
0: Without calculation
1: With calculation
$MM_TRACE
Test flags for internal diagnosis
Min. input limit: 0000
Protection level: 1/1
Bit 0: Reserved
Bit 1: Display system messages from HMI in the dialog line (for diagnostics purposes only).
Bits 2 to 4: Reserved
7.2
Display machine data for ShopMill
Max. input limit: –
Units: –
Valid as of software version
ShopMill 6.3
Max. input limit: FFFF
Units: Hex
Valid as of software version
ShopMill 6.3
7 Machine Data
J
7-67
Advertisement
Table of Contents
