Description Of Display Machine Data - Siemens SINUMERIK 840DE sl Commissioning Manual
For cnc shopmill
Hide thumbs
Also See for SINUMERIK 840DE sl:
- Commissioning manual (1734 pages) ,
- Function manual (356 pages) ,
- Manual (92 pages)
Table of Contents
Advertisement
7 Machine Data
7.2
Display machine data for ShopMill
7.2.2
Description of display machine data
9014
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
9020
MD number
Default setting: 2
Change becomes effective after: POWER ON
Data type: BYTE
Significance:
9422
MD number
Default setting: 1
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9426
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
7-46
$MM_USE_CHANNEL_DISPLA Y_DATA
Use channel–specific display machine data
Min. input limit: 0
Protection level: 3/4
In this MD you determine whether you want to use channel–specific display.
0 = No channel–specific display
1 = Channel–specific display
Note: With ShopMill this must be set to MD = 0.
$MM_TECHNOLOGY
Basic configuration turning/milling
Min. input limit: 0
Protection level: 3/4
In this MD you stipulate the basic configuration for simulation and free contour program-
ming.
0 = No specific configuration
1 = Turning machine configuration
2 = Milling machine configuration
$MM_MA_PRESET_MODE
Preset/basic offset in JOG
Min. input limit: 0
Protection level: 3/4
In this MD you stipulate the behavior of the function "Set zero offset" in "Machine – manual"
mode.
≠ 2: Zero point is saved in the currently active zero offset, in other cases it is saved in the
basic offset
= 2: Zero point is saved in basic offset
$MM_MA_AX_DRIVELOAD_FROM_PLC1
Machine index of an analog spindle
Min. input limit: 0
Protection level: 3/4
You enter the machine index of an analog spindle for the drive load display in this MD.
The thread tapping is carried out with an analog tool spindle with compensation chuck.
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Max. input limit: 1
Units: –
Valid as of software version:
ShopMill 6.4
Max. input limit: 2
Units: –
Valid as of software version:
ShopMill 6.1
Max. input limit: 3
Units: –
Valid as of software version
ShopMill 6.4
Max. input limit: 31
Units: –
Valid as of software version
ShopMill 6.4
© Siemens AG 2006 All Rights Reserved
11/2006
Advertisement
Table of Contents
