Siemens SINUMERIK 840DE sl Commissioning Manual page 62
For cnc shopmill
Hide thumbs
Also See for SINUMERIK 840DE sl:
- Commissioning manual (1734 pages) ,
- Function manual (356 pages) ,
- Manual (92 pages)
Table of Contents
Advertisement
7 Machine Data
7.2
Display machine data for ShopMill
9721
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9723
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9724
MD number
Default setting: 5000
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9725
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
7-62
$MM_CMM_ENABLE_TRACYL
Enable signal for cylinder surface transformation
Min. input limit: 0
Protection level: 3/4
Enable the cylinder surface transformation function on the operator interface:
0 = The cylinder surface transformation function is not displayed on the operator interface.
1 = The cylinder surface transformation function is displayed on the operator interface.
The cylinder surface transformation function can only be used if it has been started up in
the CNC–ISO operator interface.
$MM_CMM_ENABLE_SWIVELING_HEAD
Enable swiveling
Min. input limit: 0
Protection level: 3/4
Enable the Swiveling function on the operator interface.
0 = The Swiveling function is not displayed on the operator interface
1 = The Swiveling function is displayed in the operator interface
Swiveling can only be used if it has been started up in the CNC–ISO operator interface.
$MM_CMM_CIRCLE_RAPID_FEED
Rapid feed for positioning on circular path
Min. input limit: 0
Protection level: 3/4
Use this MD to set the rapid traverse feed in mm/min for positioning on a circular path.
$MM_CMM_ENABLE_QUICK_M_CODES
Enable fast M functions
Min. input limit: –
Protection level: 3/4
This MD is used to enable fast M functions. This means that the M functions are executed
by the PLC without confirmation.
Bit 0: Coolant 1 ON
Bit 1: Coolant 2 ON
Bit 2: Coolant 1 and 2 ON
Bit 3: Coolant OFF
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Max. input limit: 1
Units: –
Valid as of software version
ShopMill 5.1
Max. input limit: 1
Units: –
Valid as of software version
ShopMill 5.1
Max. input limit: 100000
Units: mm/min
Valid as of software version
ShopMill 6.2
Max. input limit: –
Units: –
Valid as of software version
ShopMill 6.4
© Siemens AG 2006 All Rights Reserved
11/2006
Advertisement
Table of Contents
