Nck Startup - Siemens SINUMERIK 840DE sl Commissioning Manual
For cnc shopmill
Hide thumbs
Also See for SINUMERIK 840DE sl:
- Commissioning manual (1734 pages) ,
- Function manual (356 pages) ,
- Manual (92 pages)
Table of Contents
Advertisement
11/2006
4.2.5
NCK startup
SINUMERIK
840D sl
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
The startup of the NCK features the following items:
S
Set up axes and spindles
S
Load ShopMill machine data, definitions and cycles
S
Set up tool management
You only need to set up the axes and spindles if you have not yet done so on
the machine. When setting up the axes and spindles please observe the gen-
eral conditions; (see Section 2 "General conditions").
Similarly, you only need to set up tool management in the NCK if this does not
yet exist.
Note:
Sample files are located in the directory under
CYCLES\SC\PROG\TEMPLATES_DEU or CYCLES\SC\PROG\
TEMPLATES_ENG.
If axes and spindles have not yet been
set up:
Adapt the standard MD to the axes and
spindles of the machine.
Check the MDs in the mask
"Machine data" and, if necessary, change
the axis setting data (see chap. 7.1 "NCK
machine data for ShopMill")
NCK Reset
Fig. 4-3
NC SINUMERIK 840D sl installation and startup
4 Commissioning
4.2
Initial start–up
1
4-23
Advertisement
Table of Contents
