Siemens SINAMICS G150 Operating Instructions Manual page 219

Converter cabinet units 75 kw to 1500 kw

Hide thumbs Also See for SINAMICS G150:

Table of Contents

Configuring the motor – Selecting the motor type

⇒ Under Motor name: enter a name for the motor.

⇒ From the selection box next to Motor type: select the appropriate motor for your

application.

⇒ In the Parallel connection motor field, enter the number of motors connected in parallel, if

necessary. Motors connected in parallel must be of the same type and size.

The steps described below also apply to commissioning an induction motor.

When commissioning a permanent-magnet synchronous motor, there are a few special

conditions that apply, which are detailed in a separate chapter (see "Setpoint channel and

closed-loop control / permanent-magnet synchronous motors").

⇒ Click Continue >

Converter cabinet units

Operating Instructions, 03/2012, A5E03263466A

Configuring the motor – Selecting the motor type

5.3 Procedure for commissioning via STARTER

Commissioning