Customer Terminal Module Tm31 (-A60) (Option G60) - Siemens SINAMICS G150 Operating Instructions Manual

Converter cabinet units 75 kw to 1500 kw

Hide thumbs Also See for SINAMICS G150:

Table of Contents

Customer terminal module TM31 (-A60) (option G60)

The factory setting and description of the customer terminal blocks can be found in the circuit

The location of the customer terminal block in the cabinet unit is indicated in the layout

Shield connection

The shield connection of shielded control cables on the customer terminal block –A60 is

established in the immediate vicinity of the terminal block. For this purpose, the customer

terminal block –A60 and the mounting plates have cut-out sections which are used to snap

the enclosed shield springs into place. The shields of incoming and outgoing cables must be

applied directly to these shield connections. It is important here to establish the greatest

possible area of contact and a good conductive connection.

These shield springs can be used for all control cables in the cabinet unit because all the

shield connections are identical in design.

Shield springs inherently have sharp edges resulting in the risk of cuts!

Converter cabinet units

Operating Instructions, 03/2012, A5E03263466A

Shield connection

Electrical installation

4.10 Signal connections