Setting The Water Hardness; Checking The Water Hardness Level; Service Mode 1; Table 6-27: G 681, G 881 Novo Stella, G 886 Novo Stella Plus Programming Functions - Miele G 600 Series Technical Information
(all us models)
Hide thumbs
Also See for G 600 Series:
- Installation instructions manual (40 pages) ,
- User manual (108 pages) ,
- Installation instructions manual (40 pages)
Table of Contents
Advertisement
G 600/G 800
mode. The display will show a program index number of P00 or P01, depending
on the software version.
3. Turn the program selector switch to the position indicated in Table 6-27 to modify
the corresponding function.
4. Use the Top solo button to toggle the functions on or off.
5. After selecting options, press the Start button twice, turn the program selector
switch to Stop and turn the dishwasher off.
Selector switch
position (o'clock)
2
4
9
Table 6-27: G 681, G 881 Novo Stella, G 886 Novo Stella Plus Programming Functions
1
If "0" is displayed, the dishwasher is programmed for "without water softener". To change to "with
water softener", follow the steps in Service Mode 2 (Section 6.8.5.3).
2
Factory setting
6.8.5.1.1
Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Use the Top solo button to toggle through to the desired water hardness amount.
4. To save: Press the Start button twice, turn the program selector switch to Stop and turn
the dishwasher off.
6.8.5.1.2
Checking the Water Hardness Level
1. Access Programming Mode.
2. Turn the program selector switch to the 2 o'clock position.
3. The number in the display will indicate the programmed water hardness setting (see
Table 6-27).
4. Turn the program selector switch to Stop and turn the dishwasher off.
6.8.5.2
Service Mode 1
1. To access the Manual Step Mode, close the door and turn the program selector
switch to Stop. Turn the dishwasher off.
2. Press and hold the Delay Start and Top solo buttons while turning the
dishwasher on. A dot (.) in the display and lit Intake/Drain light indicates
successful accessing of Service Mode 1.
3. Select a program and press the Start button. The display will show the current
program step.
4. Pressing the Start button repeatedly will allow the technician to advance through
the program manually. If the Start button is not pressed, the program steps are
carried out automatically, in their normal order.
Service Mode 1 can be activated at any time during a program wash cycle.
5.
When it is activated at any time during a program wash cycle, the display will
show the current program step.
Note: The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.
Program Function Chart
Function
Water hardness
setting
Buzzer
Extended drying (14
minutes)
99
Technical Information
Options
1
0 gpg
2
1 - 36 gpg
2
On
Off
2
70 seconds
100 seconds
Display
1 - 36 gpg
40
41
90
91
Advertisement
Table of Contents
