Test Program; Service Mode 2; Table 6-4: G 841, G 841 Plus, G 842 Service Mode 2 Functions - Miele G 600 Series Technical Information
(all us models)
Hide thumbs
Also See for G 600 Series:
- Installation instructions manual (40 pages) ,
- User manual (108 pages) ,
- Installation instructions manual (40 pages)
Table of Contents
Advertisement
Technical Information
Note: The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.
5. If the dishwasher door is opened and closed or the dishwasher is turned off and
on, the service mode will be canceled and the machine will continue to advance
normally.
6.8.1.2.1
Test Program
The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Turn the program selector switch to the 11 o'clock position and press the Start button.
The test program will start and advance automatically.
3. Pressing the Start button repeatedly will allow the technician to advance through the
program. If the Start button is not pressed, the program will run automatically.
6.8.1.3
Service Mode 2
Service Mode 2 is used to determine which upper electronic is in the machine, to
change certain programmed functions and to access fault codes. The programmed
functions include increasing the water temperature, turning on or off the water
softener, adding an interim rinse, and setting the dishwasher width (18" or 24").
1. To access Service Mode 2, close the door and turn the program selector switch
to Stop.
2. Turn the dishwasher off.
3. Press and hold the Start button while turning the dishwasher on. Release the
Start button and immediately press it 2 more times. Flashing Intake/Drain and
Salt lights indicates successful accessing of Service Mode 2.
4. Turn the program selector switch to the appropriate position in Table 6-4 to
access the various functions of Service Mode 2.
Selector switch
position (o'clock)
1
2
4
5
6
7
8
10
Table 6-4: G 841, G 841 Plus, G 842 Service Mode 2 Functions
1
G 841 Plus only
Function
Fault codes
Program index
1
EGS
Increase temperature
Water softener
1
Increase water intake
2 interim rinses
Dishwasher width
84
Options
Start light status
See Table 6-5
Flashing
See Table 6-6
Flashing
On
On
Off
Off
150°F
Off
160°F
On
With
Off
Without
On
On
On
Off
Off
Without
Off
With
On
24"
Off
18"
On
G 600/G 800
Advertisement
Table of Contents
