Software User Manual
12/10/09
4 Click Save to complete the graph setup.
The background you uploaded to the switch appears in the background of the graph.
You can create multiple graphs. For example, if your network spans multiple floors or buildings, you might have a graph for
each area. Additional graphs that you create appear as tabs at the top of the graph panel, as the following figure shows.
To create additional graphs, repeat the steps in this section.
Graphing the WLAN Components
The WLAN Visualization tool automatically shows the WLAN components that the switch has discovered.
The panel lists the following component types:
•
Switches (Unified Switch and peer switches)
•
Managed Access Points
•
RF Scan Access Points
These components appear in the panel on the left until you drag them onto the graph. From the View menu, you can choose
to view the components in a list view, which shows all three types of components in the left panel or in a tabbed view, which
shows one type of component at a time, organized by tabs.
tabbed view of the same components. RF Scan Access points are listed by MAC address, whereas managed access points
and switches are listed by IP address.
Document
34CSFP6XXUWS-SWUM100-D7
Figure 368: Multiple Graphs
Figure 369 on page 534
D-Link Unified Access System
shows an example of a list view and a
Visualizing the Wireless Network
Page 533