Table of Contents
Advertisement
D-Link Unified Access System
Field
RADIUS Authentication
Server Name
RADIUS Authentication
Server Configured
RADIUS Accounting
Server Name
RADIUS Accounting
Server Configured
RADIUS Accounting
Country Code
W
D
IRELESS
ISCOVERY
The Unified Switch can discover, validate, authenticate, or monitor the following system devices:
•
Peer wireless switches
•
APs
•
Wireless clients
•
Rogue APs
•
Rogue wireless clients
The Unified Switch can discover peer wireless switches and APs regardless of whether these devices are connected to each
other, located in the same Layer 2 broadcast domain, or attached to different IP subnets.
You can enable discovery between the switch and peer switches or APs by using one of following four mechanisms:
1 Manually add the IP address of the switch to the AP when it is in Standalone mode.
2 Configure a DHCP server to include the switch IP address in the DHCP response to the AP DHCP client request.
3 Use VLANs to broadcast the L2 Wireless Device Discovery Protocol.
4 Manually add the IP address of the AP to the switch.
Page 414
Basic Setup
Table 257: Basic Wireless Global Configuration
Description
Enter the name of the RADIUS server used for AP and client authentications when a network-
level RADIUS server is not defined on the Basic Setup > SSID > Wireless Network
Configuration page. The name can contain up to 32 alphanumeric characters. Spaces,
underscores, and dashes are also permitted.
The switch acts as the RADIUS client and performs all RADIUS transactions on behalf of the
APs and wireless clients.
Indicates whether the RADIUS authentication server is configured. To configure RADIUS
server information, go to LAN > Security > RADIUS > Server Configuration.
Enter the name of the RADIUS server used for reporting wireless client associations and
disassociations when a network-level RADIUS accounting server is not defined on the Basic
Setup > SSID > Wireless Network Configuration page.
The name can contain up to 32 alphanumeric characters. Spaces, underscores, and dashes
are also permitted.
Indicates whether the RADIUS accounting server is configured. To configure RADIUS
accounting server information, go to LAN > Security > RADIUS > Accounting Server
Configuration.
Select this option to enable RADIUS accounting for wireless clients.
Select the country code that represents the country where your switch and APs operate. When
you click Submit, a pop-up message asks you to confirm the change.
Wireless regulations vary from country to country. Make sure you select the correct country
code so that your WLAN system complies with the regulations in your country.
Note: Changing the country code disables and re-enables the switch. Any channel and radio
mode settings that are invalid for the regulatory domain are reset to the default values.
The country code (IEEE 802.11d) is transmitted in beacons and probe responses from the
access points.
C
ONFIGURATION
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09
- Quick Links:
- Section 1: Getting Started
Hide quick links:
Advertisement
Table of Contents
