Hitachi PC-ARF Technical Catalogue page 119

Hide thumbs Also See for PC-ARF:

Table of Contents

4 Individual remote controls

Check Interval

When the motion sensor detects an absence at selected check interval time, the function "If absent" will be executed. The

interval can be selected from 30, 60, 90 120 or 180 minutes.

(The default setting is 30 minutes.)

Setting of motion sensor

1 Press " " (menu). Select "Motion Sensor Setting" from the

menu by pressing " " or " " and press "OK".

2 "Motion Sensor Setting" is displayed. The highlighted item is

shifted to "Sensor", "If absent" and "Check interval" by press-

ing " " or " ".

To set "Sensor", go to step 3. To set "If absent", go directly to step

5. To set "Check interval", go directly to step 7.

3 Press " " or " " and select "Sensor".

4 The display is switched "ON" and "OFF" in order by pressing "

" or " " and change the setting.

If other settings are not required, go directly to step 9.

5 Press " " or " " and select "If absent".

6 The display is switched "Running", "Stand-by" and "Stop" in

order by pressing " " or " " and change the setting.

If other settings are not required, go directly to step 9.

TCGB0106 rev.0 - 12/2014

Louver Setting

Louver Open/Close

Total Heat Exchanger SET

Motion Sensor Setting

Motion Sensor Setting

Check interval

Motion Sensor Setting

Check interval

Motion Sensor Setting

Check interval

Motion Sensor Setting

Check interval

Motion Sensor Setting

Check interval

Troubleshooting