Table of Contents
Advertisement
6. Power ON/OFF
6.1
Power ON
CAUTION:
Make sure that no recording media is present in the corresponding drives
before the system power is turned ON. Otherwise, the media may be
damaged or a malfunction may result.
(1) Check the items below before turning the power ON.
• The power cable should be connected.
• One or more transducer should be connected.
(2) Turn ON the main switch on the power panel on the rear of the system. The
STANDBY LED blinks.
(3) Turn ON the subswitch. Some time after the setup screen is displayed, the
B-mode screen appears. Note that this subswitch does not light even when it is
turned ON.
(4) If required, adjust the brightness and contrast using the corresponding knobs
(
,
) on the CRT monitor or the buttons on the front of the LCD monitor.
(a) Set the contrast to minimum. The image disappears.
(b) Adjust the brightness so that the brightness level of the screen is the same as
in the examination room.
(c) Then adjust the contrast to set the maximum luminance.
NOTE:
When this system is started up or another transducer is selected, you
may hear a click. This does not indicate abnormality.
6.2
Power OFF
CAUTION: 1. Do not turn the system power OFF while a recording media is being
2. If the power cannot be turned OFF by the normal procedure, turn OFF
(1) Before turning OFF the system, confirm that the CD-R or HDD is not being
accessed.
(2) Turn OFF the subswitch. The STANDBY LED blinks.
(3) When the system is not going to be used for an extended period of time, turn OFF
the main switch on the power panel and disconnect the power plug.
accessed. If the system power is turned OFF during access to the hard
disk, floppy disk, or magneto-optical disk, the disk may be damaged
and recorded data may be lost.
the main switch on the power supply panel at the rear of the system.
These methods should not be used under normal conditions. They may
damage the system.
No. 2B730-973EN*D
6-1
Advertisement
Table of Contents
