58
en | Installing
On the upper side of the AMC panel, put the jumper on the two pins on the right hand side of
connector 8. Also refer to .
Set the RS-485 address of the AMC2 controller using the DIL switch. Refer to DIL switch
selector, page 61.
Refer to
–
–
–
4.9.2
RS-485 Four Wire Connection
Figure 4.40: Connection scheme of an RS-485 four wire connection
1 =
2 =
3 =
4 =
5 =
6 =
Figure 4.41: Settings for RS-485 four wire connection
2020-01 | V02 |
, page 16
, page 17
, page 17
shield
TxRx+
TxRx-
signal ground
Tx+
Tx-
Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.