44
en | Installing
Settings for jumper JP2:
If the ground conductor and the shield on the host are not connected and:
–
–
–
Settings for the jumper:
If the ground conductor and the shield on the host are not connected and:
–
–
–
4.6.2
Grounding for Extension Interface
B 1:
B 2:
Figure 4.16: Location of ground jumper bottom side
Figure 4.17: Location of ground jumper bottom side
Figure 4.18: Location of ground jumper bottom side
2020-01 | V02 |
no party line exists, the jumper JP2 is set (= A3)
a party line exists and signal ground is connected, the jumper JP2 is set at the first device
only (= A3)
a party line exists and signal ground is not connected, the jumper JP2 is set at all devices
(= A3)
no party line exists, the jumper is set
a party line exists and signal ground is connected, the jumper is set at the first device
only
a party line exists and signal ground is not connected, the jumper is set at all devices
Delivery status
B
Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.