54
en | Installing
Access Modular Controller 2
Figure 4.32: Location of the Ethernet interface
Notice!
After connecting a new AMC2 device to a network using DHCP, it can take some time before
the new AMC2 device is recognized by the remote server.
You can accelerate this process by running the following command:
ipconfig /flushdns
This makes the AMC2 device immediately available by its name.
Notice!
Using the Ethernet connection, the switches 1 and 5 must remain in Pos. ON (=factory
setting).
2020-01 | V02 |
Installation manual
Bosch Access Systems V.B.