Table of Contents
Advertisement
6-4-4. Setmib Command
This command is used to set the MIB parameters.
Command format : setmib nn (Setting contents of the item.)
setmib save (Saving the set item.)
Specify the item number "nn" of the command to be set. (Refer to Section 6-4-5.)
n
The set item will not be saved until "setmib save" is executed. Be sure to execute the setmib save com-
mand to save the setup.
Execution example
1. Enter "setmib 1".
2. Enter a new value in New Value.
3. Enter "setmib save".
The setup is saved.
SNMPCmd>setmib 1
OID = 1.3.6.1.2.1.1.4.0
MIB Name = sysContact
Now value:
New value: test
update complete.
SNMPCmd>setmib save
Factory Setups was saved into Flash memory.
PDJ-A640 IM
6-7 (E)
Advertisement
Table of Contents
