Yamaha ERCX Series User Manual page 162
Single-axis robot controller
Hide thumbs
Also See for ERCX Series:
- User manual (148 pages) ,
- Supporting supplement manual (34 pages)
Table of Contents
Advertisement
9-3 Using Automatic Operation
9
10
9-
8) This is the screen displayed while the program
is being executed.
9) Pressing
during execution brings the ro-
STOP
bot to a halt and displays the message "stop
key". Press the
key to display the step
ESC
where execution was interrupted.
Pressing
will cause execution to resume
RUN
from the step where it was interrupted. When
the last step has been executed, the message
"program end" is displayed. Pressing the
key returns the screen to that shown in Step 7.
10)To switch to the display of another task in a
multi-task program, press
the function menu display and then press
(CHGT).
11)Each time you press
F2
display is switched.
12)To return to the first step of the program from
any other step and initiate execution again, press
(RSET).
F2
13)The screen returns to step 5, and the process is
repeated from that point.
c
CAUTION
When the SERVICE mode function is enabled, the following safety control will function. (See "10-4 SERVICE
mode function".)
• Automatic operation cannot be performed in "SERVICE mode state" when automatic operation and step
operation are prohibited.
• Robot movement speed is limited to 3% or less of maximum speed in "SERVICE mode state" when the robot
movement speed limit is enabled.
• If the hold-to-run function is enabled, automatic operation stops upon releasing
state".
ESC
(next) to change
F4
F2
(CHGT), the task
[OPRT-AUTO]
running ...
[OPRT-AUTO]
60:program end
[OPRT-AUTO] 50
1:11
010:WAIT 0
,1
[
250.00]
1S_ON2CHGT3MIO 4next
[OPRT-AUTO] 50
2:12
015:DO
1
,1
[
250.00]
1S_ON2CHGT3MIO 4next
[OPRT-AUTO] 50
0:10
035:TIMR 100
[
250.00]
1SPD 2RSET3CHG 4next
[OPRT-AUTO] 50
0:10
001:MOVA 999,50
[
250.00]
1SPD 2RSET3CHG 4next
in "SERVICE mode
RUN
Advertisement
Table of Contents
Troubleshooting
