Siemens SINUMERIK 840D sl Programming Manual page 421

Job planning

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Specifying the repositioning point (not for SERUPRO approaching with RMN)

With reference to the NC block in which the program run has been interrupted, it is possible

to select one of three different repositioning points:

• RMI, interruption point

• RMB, block start point or last end point

• RME, block end point

RMI DISPR=... or RME DISPR=... allows you to select a repositioning point which sits before

the interruption point or the block end point.

DISPR=... allows you to describe the contour distance in mm/inch between the repositioning

point and the interruption before the end point. Even for high values, this point cannot be

further away than the block start point.

If no DISPR=... command is programmed, then DISPR=0 applies and with it the interruption

point (with RMI) or the block end point (with RME).

Job planning

Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0

9.9 Repositioning at contour (REPOSA/L, REPOSQ/H, RMI, RMN, RMB, RME)

Path traversing behavior