Siemens SINUMERIK 840D sl Programming Manual page 330
Job planning
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Tool offsets
8.3 Online tool compensation (PUTFTOCF, PUTFTOC, FTOCON, FTOCOF)
Programming
FCTDEF(Polynomial_no., LLimit, ULimit,a0,a1,a2,a3)
or
PUTFTOCF(Polynomial_No., Ref_value, Length1_2_3, Channel, Spindle)
or
PUTFTOC(Value, Length1_2_3, Channel, Spindle)
or
FTOCON
or
FTOCOF
Parameters
PUTFTOCF
FCTDEF
PUTFTOC
FTOCON
FTOCOF
Polynomial_No.
Ref_value
Length1_2_3
Channel
Spindle
LLimit
ULimit
a
,a
0
Value
8-8
Write online tool offset continuously
Define parameters for PUTFTOCF function
Write online tool offset discretely
Activation of online tool offset
Deactivation of online tool offset
Values 1 to 3: up to 3 polynomials are possible at one time;
polynomial up to 3rd order
Reference value from which the offset is derived
Wear parameter into which the tool offset value is added
Number of channel in which the tool offset is activated;
specified only if the channel is different to the present one
Number of the spindle on which the online tool offset acts;
only needs to be specified for inactive grinding wheels
Upper limit value
Lower limit value
,a
,a
Coefficients of polynomial function
1
2
3
Value added in the wear parameter
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
Job planning
Advertisement
Table of Contents
