Contour Turning With Manual Machine - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
If you want to rework some threads, input the initial plunge depth D0 (inc.). This is the depth that
was reached during a previous machining.
Note
By inputting the plunge depth, you avoid unnecessary idle cuts when reworking the threads.
B axis
16.6.3
Contour turning with Manual machine
For contour turning of simple geometric shapes, the same range of technological functions
(cycles) as in automatic mode is available.
Parameters
The parameters of the input screen forms correspond to the parameters under Automatic (see
Section Contour turning (Page 442)).
Last contour
Turning
Operating Manual, 06/2019, A5E44903486B AB
Machine manufacturer
Please refer to the machine manufacturer's specifications.
⇒
If you have created a contour since the startup of the machine, the "Last con‐
tour" softkey is available. You then have the option to reopen the input screen
with the last contour you entered in "Manual machine" for editing.
Working with Manual Machine
16.6 More complex machining
⇒
871
Advertisement
Table of Contents
