Cleaning Mode; Display Live Image From A Camera - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Introduction
2.4 User interface
2.4.15
Cleaning mode
In cleaning mode, you can clean the user interface of the panel without inadvertently initiating
touch functions.
When you activate cleaning mode, the system does not respond when you touch the screen.
Switching over to another panel and entering data at the keyboard are deactivated. The display
is dimmed. The progress bar shows the remaining time in seconds.
Depending on the setting, cleaning mode lasts between 10 seconds and 1 minute. You can
work as usual once this time has expired.
Note
Use a suitable cleaning agent to clean the screen.
Procedure
2.4.16
Display live image from a camera
In SINUMERIK Operate, you can display a live image from a camera.
● The camera image allows you to track remote processes and monitor difficult-to-access
areas.
● You can also document and store machine states.
● You can create and configure up to two cameras.
You configure the cameras in the "Camera configuration" window, which you call with the
"Camera" softkey in the "Setup" operating area.
Requirement
● The cameras used meet the required criteria for maximum resolution, frame rate,
compression rate and network capability.
● You have configured the cameras used.
66
1.
Select the "Start-up" operating area.
2.
Press the "Cleaning mode for panel" softkey.
The system switches into cleaning mode.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Operating Manual, 06/2019, A5E44903486B AB
Turning
Advertisement
Table of Contents
