Sony DVS-9000 User Manual page 210
Production switcher system with center control panel
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
6
Carrying out a color mix for key fill
When [Matte] is selected for key fill, you can combine color 1 and color 2. For
the combination, you can use not only a key wipe generator pattern, but also
the dedicated pattern for key edge color mix.
Use the following procedure.
1
2
3
4
210
Key Setting Operations Using Menus
Auto Select: The signal allocated, being paired with the key fill bus signal,
to a cross-point button is automatically selected as the key source. The
setting of key fill and key source pairs is carried out in the Setup menu.
(See "Cross-Point Settings (Xpt Assign Menu)" in Chapter 16
(Volume 2).)
Split: You can select a key source signal independently of the key source
automatically selected in Auto Select mode.
When [Split] was selected in step 5, to select the key fill signal, press the
key delegation button [KEY], turning it on, then press the appropriate
button in the key row. To select the key source signal, hold down the
[KEY1] button and press the corresponding button in the key row.
In the <Key Fill> group of the Type menu, select [Matte] and press [Matte
Adjust].
The Matte Adjust menu appears.
Select [Mix Color] in the <Fill Matte> group.
Adjust the following parameters.
Knob
Parameter
Adjustment
1
Size
Pattern size
2
Soft
Softness of the edge of the
pattern
Select the combining pattern in the <Mix Pattern> group.
Key Wipe: The wipe pattern selected for an independent key transition is
used for combination.
Edge Pattern: Combine using the dedicated pattern selected for the color
mix in the key edge fill.
For details, see "Carrying out a color mix for the key edge fill matte"
(page 214).
Setting values
0.00 to 100.00
0.00 to 100.00
Advertisement
Table of Contents
