Sony DVS-9000 User Manual page 124
Production switcher system with center control panel
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
Operating mode setting
• Single Proc mode: The control panel controls a single switcher.
• Dual Simul mode: The control panel controls two switchers.
Device hierarchical relationship setting
• Panel Assign: Specify the switcher controlled by a control panel.
• Switcher Assign: Specify the DME connected to a switcher.
Signal format settings (Format)
Make the following settings.
Signal format
Specify the signal format to be handled by the devices.
The combinations of signal formats that can be selected are as follows.
Field frequency
59.94
50
Screen aspect ratio
Switch the screen aspect ratio to 4:3 or 16:9.
Selecting the start up state (Start Up)
Set the initial state of the devices when the system is powered on.
For each device, you can select Resume mode or Custom mode.
Resume mode
This resumes the setting state at the previous power-off operation. This setting
is only available for the switcher processor and panel.
Custom mode
This uses the settings saved in non-volatile memory or ROM within the device.
In this mode, there are Setup and Initial Status settings which can be set
separately.
• Setup mode: Select the setup state to be used after powering on from the
following.
• Initial status mode: Select the state of each device after powering on
(excluding the settings to which "setup" applies).
124
Setup
User: Start up using the user data previously saved with [Setup Define].
Factory: Start up with the factory default settings.
User: Start up using the user data previously saved with [Initial Status
Define].
Factory: Start up with the factory default settings.
Effective number of scan lines
480i
576i
Advertisement
Table of Contents
