Transition Preview - Sony DVS-9000 User Manual
Production switcher system with center control panel
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
Transition Preview
Carrying out a transition preview
To carry out a transition preview, use the following procedure.
For an overview of the transition preview, see page 34.
1
2
To terminate a transition preview
There are three modes for a transition preview. To terminate a transition
preview, carry out the operation which depends on the mode, and press the
[TRANS PVW] button, turning it off.
Lock: Toggling the [TRANS PVW] button on and off switches between the
Hold: The preview mode obtains only while the [TRANS PVW] button is held
One Time: Each time a transition ends, it reverts to the normal mode.
For details of the mode setting, see "Settings Relating to Video Switching
(Transition Menu)" in Chapter 16 (Volume 2).
Notes
• During a transition, whether executed with the [AUTO TRANS] button or
the fader lever, it is not possible to press the [TRANS PVW] button.
• In bus fixed mode (see page 33), transition previews are not available.
196
Transition Preview
In the M/E or PGM/PST bank transition control block, press the [TRANS
PVW] button.
The [TRANS PVW] button lights green, and the switcher is now in the
transition preview mode. At this point, the preview output is the same as
the program output before the [TRANS PVW] button was pressed.
Operate the fader lever, or press the [AUTO TRANS] button or [CUT]
button.
On the preview monitor, you can check the effect of the transition.
transition preview mode and the normal mode.
down.
Advertisement
Table of Contents
