Executing An Auto Transition - Sony DVS-9000 User Manual
Production switcher system with center control panel
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
Executing an Auto Transition
To execute a transition on the M/E or PGM/PST bank by a button operation,
use the following procedure in the transition control block.
192
Executing a Transition
• When you press the [CUT] button, the pattern limit is immediately
released, and the image switches instantaneously.
• When you press the [AUTO TRANS] button, until the state of the next
transition, the transition is carried out over the duration given by the
transition rate.
• When you move the fader lever, the transition is carried out from the
pattern limit state to the state before the pattern limit transition was
carried out.
However, moving the fader lever even a little synchronizes the fader
lever position with the transition state, and you can move the fader lever
either in the forward direction or in the reverse direction.
Depending on the Setup settings, the transition may be executed at the
instant you press the [PTN LIMIT] button, and the button goes off. In this
case, execution continues for the time specified by the dedicated transition
rate in the menu setting, as far as the state of the next transition.
For details of the setting, see "Settings Relating to Keys, Wipes and Frame
Memory (Key/Wipe/FM Menu)" in Chapter 16 (Volume 2).
Fader lever
AUTO TRANS button
CUT button
ON
ON
ON
ON
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
BKBD
KEY1
KEY2
KEY3
KEY4
KEY
SUPER
MIX
NAM
PRIOR
MIX
PST
COLOR
ALL
WIPE
DME
MIX
PRIOR
NORM
TRANS
NORM
REV
SET
/REV
PVW
AUTO
TRANS
Transition control block
CUT
PTN
LIMIT
KF
LIMIT
SET
Advertisement
Table of Contents
