Installation - Suzuki SQ416 Service Manual

Volume 1 of 2 chassis/electrical/body

Hide thumbs Also See for SQ416:

Table of Contents

INSTALLATION

Reverse removal sequence to install condenser, noting following

1) When replacing condenser, add 20 to 30 cc of refrigerating oil

from compressor suction-side.

2) Evacuate and charge system according to previously-described

RECEIVER/DRYER (IF RECEIVER/DRYER IS

INDEPEND OF CONDENSER)

Use a leak tester to check for gas leakage, sight glass and fittings.

1) Recover refrigerant by using recovery and recycling equipment.

Be sure to follow the instruction manual for the equipment.

The amount of compressor oil removed must be measured and

the same amount must be added to the system when reinstal-

2) Disconnect liquid line pipes.

3) Remove receiver/dryer from its holder.

1. Receiver / dryer

2. Liquid line pipe

INSTALLATION

1) Reverse removal sequence to install receiver/dryer.

D When replacing receiver/dryer, add 10 cc of refrigerating

oil from compressor suction-side.

D Blind plugs of receiver/dryer should not be removed until

just before receiver/dryer is installed.

2) Evacuate and charge system according to previously-described

AIR CONDITIONING (OPTIONAL) 1B-23

Show Quick Links

Table of Contents