3E-16 REAR SUSPENSION
REAR AXLE HOUSING
REMOVAL
1) Drain differential gear oil.
2) Remove rear brake drum. (Refer to steps 1) to 5) of BRAKE
3) Disconnect brake pipe from wheel cylinder. With right side wheel
1. Brake pipe flare nut
2. Brake pipe
3. Brake back plate
4) Remove rear wheel bearing retainer nuts from rear axle hous-
1. Nut
5) Check to ensure that there is clearance between rear wheel
1. Bearing retainer
2. Parking brake shoe
lever
3. Clearance
6) Using special tools (B) & (C) indicated below, draw out axle
Carry out steps 2) to 8) and 16) to 19) on both right and left
wheels.
Note that left wheel and its related parts are used in illustrations
in this section.
DRUM REMOVAL.)
cylinder, disconnect 2 brake pipes.
ing.
bearing retainer and parking brake shoe lever. If no clearance
is found, loosen cable locking nut further to obtain clearance.
shafts. For vehicle equipped with ABS, remove wheel speed
sensor from axle housing before drawing out axle shaft.
NOTE:
Use care not to pull brake back plate along with shaft.
Special Tool
(C): 09943-35512
(B): 09942-15510