Suzuki SQ416 Service Manual page 727

Volume 1 of 2 chassis/electrical/body

Hide thumbs Also See for SQ416:

Table of Contents

3B1-2 POWER STEERING (P / S) SYSTEM

4. Tie rod end

INSTALLATION

1) Visually inspect that rack and rack end ball joint are free from dirt

or foreign matters. Clean thoroughly with cloth or such.

Position boot properly in grooves of gear case and tie-rod and

clamp it with wire and clip.

Wire should be new and should go around twice.

Pull its both ends together by screw driver or such and make

sure that the wire won't be crossed. Then twist the ends several

times, the twisted ends should be bent in the circumferential

After this, check to ensure that wire is tight and boot is free from

twist and dent.

2) Install tie-rod end lock nut and tie-rod end to tie-rod.

Position lock nut to the mark made in removal.

3) Install steering gear box assembly by referring POWER

STEERING GEAR BOX ASSEMBLY INSTALLATION.

After installation, fill specified P/S fluid and bleed air from sys-

tem. Then check toe setting and adjust as required.

Show Quick Links

Table of Contents