1
Vehicle
inside
"A": Instantaneous adhesive area
"a": 25 – 35 mm (0.98 – 1.38 in.)
1. Partition weather strip
2. Partition glass
5) Remove outer weatherstrip.
CAUTION:
Using a tape-wrapped putty knife (or tape-wrapped
screwdriver), pry off weatherstrip. Use of an unwrapped
tool will cause damage to painting.
1. Door outer
weathership
2. Screw
6) Remove glass fitting screws. Then down door glass.
7) Detach rear part of glass run from center sash.
8) Remove door center sash (by removing two screws with door
glass lowered all the way down).
9) When remove partition glass, slide to front to remove it.
10) Take out glass.
1. Screw
2. Partition glass
3. Center sash
INSTALLATION
Reverse removal procedure to install rear door glass noting the fol-
lowing instructions.
D Secure door sealing cover with adhesive.
1. Door sealing
cover
2. Adhesive
D Apply instantaneous adhesive to hatched part "A" between parti-
tion glass and partition weather strip.
NOTE:
D Horizontal adhesive application range should be in 25 – 35
mm (0.98 – 1.38 in.) from each convex corner of partition
glass.
D Do not overflow instantaneous adhesive from edge of parti-
tion weather strip.
CAUTION:
Never use instantaneous adhesive eroding rubber.
BODY SERVICE 9-13