Suzuki SQ416 Service Manual page 197

Volume 1 of 2 chassis/electrical/body

Hide thumbs Also See for SQ416:

Table of Contents

D Press-fitting inner oil seal.

Drive in inner oil seal until its end contacts stepped surface of

knuckle using special tools.

Special Tool

(B): 09944-66010

(C): 09924-74510

D Apply lithium grease to oil seal lip and into its hollow to fill more

than 60% of its vacant space.

"B": Grease 99000-25010

D Bending ball stud split pin. (For castle nut type)

After tightening ball stud castle nut, bend split pin so that it is in

close contact with stud head or castle nut as shown. Also, be sure

to insert its bent end so that its projection ("A" in figure) is made

as small as possible.

Tightening Torque

m (5.5 kg-m, 39.0 lb-ft)

D Tighten control arm ball stud nut. (For self-locking nut type)

When tightening ball stud nut, use new nut and tighten it to speci-

fied torque.

Tightening Torque

m (6.0 kg-m, 43.5 lb-ft)

D When installing axle shaft drive flange to wheel hub, apply sealant

to mating surface of axle shaft drive flange.

"A": Sealant 99000-31090

Tightening Torque

m (2.5 kg-m, 18.0 lb-ft)

D For installation procedures following the above, refer to WHEEL

HUB/BEARING/OIL SEAL INSTALLATION of this section.

D Tightening torque.

For any tightening torque other than those specified in text, refer

to torque specification table at the end of this section.

FRONT SUSPENSION 3D-19

Show Quick Links

Table of Contents