Suzuki SQ416 Service Manual page 213

Volume 1 of 2 chassis/electrical/body

Hide thumbs Also See for SQ416:

Table of Contents

1. Wheel speed sensor

1. Bearing retainer

2. Parking brake shoe

3. Clearance

4) Remove wheel speed sensor from rear axle housing (if

equipped with ABS).

D Do not pull wire harness or twist more than necessary

D Do not cause damage to surface of rear wheel speed

5) Check to ensure that there is clearance between rear wheel

bearing retainer and parking brake shoe lever. If no clearance

is found, loosen cable locking nut further to obtain clearance.

6) Using special tools (B) & (C) indicated below, draw out axle

Use care not to pull brake back plate along with shaft.

Pull out axle shaft using care so that upper and lower

brake struts and parking cable are not caught.

Special Tool

(C): 09943-35512

(B): 09942-15510

7) Rear axle shaft that was drawn out.

Shaft length "L":

Right side: 757.5 mm (29.8 in.)

8) If equipped with ABS, in order to remove sensor rotor from re-

tainer ring, grind with a grinder one part of the sensor rotor as

illustrated till it becomes thin.

when removing rear wheel speed sensor.

sensor or pole piece and do not allow dust, etc. to enter

its installation hole.

711.5 mm (28.0 in.)

REAR SUSPENSION 3E-11

Show Quick Links

Table of Contents