Canon 1130 Service Manual page 584
Color laser copier
Hide thumbs
Also See for 1130:
- Service handbook (274 pages) ,
- Service manual (901 pages) ,
- Service manual (20 pages)
Table of Contents
Advertisement
14) Fit the developer supply funnel that
comes with the copier to the developing
assembly upright.
15) Put the developer into the developing
assembly.
•
Turn the developer container slowly
while tilting it to facilitate the work.
16) When done, press the Stop key to stop the
operation.
17) Execute STIR-Y/M/C/K in service mode
(about 10 min).
18) Execute INIT-Y/M/C/K in service mode
(about 10 min).
19) Select ADJUST>DENS in service mode.
20) Record the data of the DENS screen on
the service label.
Points to Note about the
Gradation Sensor
7
(CLC1140/1160/1180 only)
If you have removed or replaced the
Gradation sensor in No.2 blade assembly,
perform the following:
1) Clean the gradation sensor, use a flannel cloth, moistened with and then well wrung. Mount the
sensor.
The reason for using water is to remove charges from the sensor window of the
gradation sensor. (The presence of charges can attract toner to the sensor
window)
After cleaning the sensor window with water, do NOT leave droplets of water on
it, also do NOT dry wipe it.
2) Turn on the power switch, and keep the
copier in standby state.
3) Select and execute FUNCTION>SNS-
ADJ>P-SENS in service mode.
4) Record the values of ADJUST>DENS>P-
SENS-Y,M,C,K in service mode to the
service label
5) Select and execute Adjust/Cleaning>Auto
Gradation Correction in user mode.
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Figure 13-223
Figure 13-224
13-19
- Quick Links:
- Service Information
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
