8. Measure:
TIP
Measure the distance "a" only if the wheel
bearings, wheel sensor rotor, or both were
replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
wheel sensor housing "2")
Out of specification → Reinstall the bear-
ing or replace the wheel sensor rotor.
Distance
wheel sensor rotor and wheel
sensor housing)
29.2–29.7 mm (1.15–1.17 in)
9. Install:
• Rear wheel sensor "1"
Rear wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
When installing the rear wheel sensor, check
the rear wheel sensor lead for twists and the
sensor electrode for foreign materials.
ECA14500
To route the rear wheel sensor lead, refer to
"CABLE ROUTING" on page 2-39.
"a"
(between
the
10. Check:
• Rear wheel sensor installation
Check if the wheel sensor housing is
installed properly.
4-36
REAR WHEEL